Altocraft 240-2087 Manual del operador

SAVE THIS MANUALYou will need this manual for safety instructions, operating procedures and warranty. Put it and the original sales receipt in a safe

2IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric tools, machines or equipment, basic safety precautions should always be followed to reduce

3IMPORTANT SAFETY INSTRUCTIONS15. USE EYE PROTECTION. Use a full-face mask if the work you’re doing produces metal lings, dust or wood chips. Goggles

SPECIFICATIONS=Voltage: 120 volts AC, 60Hz. =Current rating: 10 amps=No-load speed: 4800 rpm =8-1/4” (210mm) 24 tooth carbide tipped saw blade=5/

5OPERATING PROCEDURES2. Engage the spindle lockby pressing the pin located between the handle and the xed guard. CAUTION: Never press the spindle lo

5. To begin cutting, lower the cutting head. The movable guard opens automati-cally.6. After cutting, allow the head to come back up. The guard will

ALIGNING MITER AND BEVELMiters and bevels have been set at the factory. However, use may effect settings. Please use the following procedures when y

8PARTS LISTPlease refer to the schematic drawing on page 9.No. Description No. Description No. Description1. Cover screw 42. Bearing cover 83.

99SCHEMATIC DRAWING !WARNING Repairs should be made by an authorized repair center. Do not this power tool. Contact atfor questions regarding this